1887

Abstract

Summary

Laboratory experiments with reservoir rock samples should give input to estimation of the potentials of recovery methods. The potential for low salinity water flooding (LSWF) of sandstone oil reservoirs has been reported to depend on the amount of clay and their surface properties. The objective for the reported study was to investigate the effect of KCl water-based mud invasion on the determined LSWF-potential. The wettability of minerals and a sandstone reservoir rock was characterized by flotation tests using two brines (formation water (FW) and mud brine) and two stock tank oils (STOs). During preparation of sandstone reservoir core plugs, effluent samples were analyzed for element compositions to determine whether they were contaminated with KCl mud. Unsteady-state flooding experiments with sea water (SW) and low salinity water (LSW) were carried out in these core plugs. Core plugs were analyzed by scanning electron microscopy (SEM) both after cleaning with solvents and after water flooding experiments. Bentonite consists mainly of montmorillonite clay and is added to water-based muds for rheology and filtration control. In the flotation tests, this clay was found to be less water-wet than the dominating minerals in the original reservoir rock. Rock samples with bentonite invasion can therefore become more oil-wet than the original rock. The mud brine was also in the flotation tests found to give more water-wet reservoir rock than the FW. High permeable sandstone reservoir core plugs were during preparation found to be contaminated by the KCl mud brine. Chemical analyses confirmed that this brine was removed during cleaning of the core plugs. In some cases, production of emulsions was observed during LSWF. These emulsions may have been stabilized by bentonite contamination. The water flooded core plugs were by SEM-analysis found to contain clusters of barite and clay and also polymer. This means that all mud components were not removed by using the standard core cleaning procedure. It was not possible to conclude anything about the LSWF-potential for the studied reservoir rock, because the core plugs were contaminated by mud components that may have affected the determined LSWF-potential.

Mud contamination of the reservoir rock can affect the permeability and the established wettability conditions. Invasion of bentonite clay will increase the cation exchange capacity, and this can affect the determined LSWF-potential. It should therefore be confirmed that mud components that can affect the established flow conditions, are removed during core preparation.

Loading

Article metrics loading...

/content/papers/10.3997/2214-4609.201700298
2017-04-24
2024-03-28
Loading full text...

Full text loading...

References

  1. Anderson, W.G.
    1986. Wettability literature survey- Part 1: Rock/oil/brine interactions and the effects of core handling on wettability. SPE-13932-PA. Journal of Petroleum Technology38 (10): 1125–1144.
    [Google Scholar]
  2. Appelo, C.A.J., and Postma, D.
    2004. Geochemistry, groundwater and pollution. CRC press, 2004.
    [Google Scholar]
  3. Choo, Ko Yeon, and KangBai
    . 2016. The effect of the mineralogical composition of various bentonites on CEC values determined by three different analytical methods. Applied Clay Science126 (2016): 153–159.
    [Google Scholar]
  4. Fjelde, I., Asen, S. M., and Omekeh, A.
    2012. Low salinity water flooding experiments and interpretation by simulations. SPE-154142-MS. SPE Improved Oil Recovery Symposium, Tulsa, OK, USA, 14–18 April.
    [Google Scholar]
  5. Fjelde, I., Omekeh, A.O. and Minde, M.W.
    2015. Removal of Mud Components from Reservoir Sandstone Rocks. SCA2015–016. International Symposium of the Society of Core Analysts, St. John’s Newfoundland and Labrador, Canada, 16–21 August.
    [Google Scholar]
  6. Fjelde, I., Polanska, A., Asen, S. M. & Taghiyev, F.
    2013. Low Salinity Water Flooding: Retention of Polar Oil Components in Sandstone Reservoirs. A24. 17th European Symp. IOR. St Petersburg, Russia. 16–18 April.
    [Google Scholar]
  7. Lager., A., Webb, K.J., Black, C.J.J., Singleton, M., and Sorbie, K.S.
    2006. Low salinity oil recovery – An experimental investigation. SCA2006-36. International Symposium of the Society of Core Analysts, Trondheim, Norway, 12–16 September.
    [Google Scholar]
  8. Lee, S.Y., Webb, K.J., Collins, I.R., Lager, A., Clarke, S.M., O’Sullivan, M., Routh, A.F., and Wang, X.
    2010. Low salinity oil recovery – Increasing understanding of the underlying mechanisms. SPE Improved Oil Recovery Symposium, Tulsa, Oklahoma, USA, 24–28 April.
    [Google Scholar]
  9. Mahani, H., Berg, S., Ilic., D., Bartles, W.-B., and Joekar-Niasar, V.
    2015. Kinetics of low-salinity-flooding effect. SPE-165255-PA. SPE Journal20 (01): 8–20.
    [Google Scholar]
  10. Mwangi, P., Thyne, G. and Rao, D.
    2013. Extensive experimental wettability study in sandstone and carbonate-oil-brine Systems: Part 1 – Screening tool development. SCA2013-84. International Symposium Society of Core Analysts. Napa Valley, California, USA, 16–21 August.
    [Google Scholar]
  11. Omekeh, A. V., Friis, H. A., Evje, S. and Fjelde, I.
    2015. A model for low salinity flooding experiments: Dissolution and ion exchange. Journal of Porous Media18 (3): 189–213.
    [Google Scholar]
  12. Omekeh, A., Evje, S., Fjelde, I., and Friis, H.
    2011. Experimental and modeling investigation of ion exchange during low salinity waterflooding. SCA2011-038. International Symposium of the Society of Core Analyst, Austin, Texas, USA, 18–21 September.
    [Google Scholar]
  13. Omekeh, A., Friis, H., Fjelde, I., and Evje, S.
    2012. Modeling of ion exchange and solubility in low salinity water flooding. SPE-154144-MS. SPE Improved Oil Recovery Symposium, Tulsa, Oklahoma, USA, 14–18 April.
    [Google Scholar]
  14. Sandengen, K., Tweheyo, M. T., Raphaug, M., Kjølhamar, A., Crescente, C., and Kippe, V.
    2011. Experimental evidence of low salinity water flooding yielding a more oil-wet behaviour. SCA2011-16. International Symposium of the Society of Core Analyst. Austin,Texas, USA, 18–21 September.
    [Google Scholar]
  15. Seccombe, J., Lager, A., Webb, K., Jerauld, G., and Fueg, E.
    2008. Improving waterflood recovery: LoSal EOR field evaluation. SPE-113480-MS. SPE/DOE Symposium on Improved Oil Recovery, SPETulsa, OK, USA, 20–23 April.
    [Google Scholar]
  16. Sharma, M. and Filoco, P.
    2000. Effect of brine salinity and crude oil properties on oil recovery and residual saturations. SPE-65402-PA, SPE Journal5 (03): 293–300.
    [Google Scholar]
  17. Shehata, A. M. and Nasr-El-Din, H. A.
    2016. Laboratory investigations to determine the effect of connate-water composition on low-salinity waterflooding in sandstone reservoirs. SPE-171690-NA. SPE Reservoir Evaluation & Engineering: Preprint.
    [Google Scholar]
  18. Skrettingland, K., Holt, K., Tweheyo, M., and Skjevrak, I.
    2010. Snorre low salinity water injection – core flooding experiments and single well field pilot. SPE-129877-MS. Symposium on Improved Oil Recovery, Tulsa, OK, USA, 24–28 April.
    [Google Scholar]
  19. Tang, G. Q. and Morrow, N. R.
    1999. Influence of brine composition and fines migration on crude oil/brine/rock interactions and oil recovery. Journal Petroleum Science Engineering. 24 (2–4): 99–111.
    [Google Scholar]
  20. Webb, K., Black, C., and Al-Jeel, H., Low salinity oil recovery– log inject log
    . 2004. SPE-89379-MS. SPE/DOE Symposium on Improved Oil Recovery, Tulsa, OK, USA, 17–21 April.
    [Google Scholar]
  21. Yildiz, H. O. and Morrow, N. R.
    1996. Effect of brine composition on recovery of Moutray crude oil by waterflooding. Journal Petroleum Science Engineering. 14 (3–4): 159–168.
    [Google Scholar]
http://instance.metastore.ingenta.com/content/papers/10.3997/2214-4609.201700298
Loading
/content/papers/10.3997/2214-4609.201700298
Loading

Data & Media loading...

This is a required field
Please enter a valid email address
Approval was a Success
Invalid data
An Error Occurred
Approval was partially successful, following selected items could not be processed due to error