1887

Abstract

Summary

Polymer flooding improves oil recovery by improving flood front conformance compared with waterflooding as well as, in some cases, extracting more oil from lower permeability zones in the reservoir by viscous cross-flow. However viscous cross-flow of water from the low permeability zone may also adversely affect the polymer flood by causing the polymer slug to be diluted and possibly to lose its integrity. The extent to which viscous cross-flow improves or reduces recovery depends upon the permeability contrast between the low and high permeability zones, the viscosity ratios of the fluids (oil, water and polymer solution) and the geometry of the layers. This paper uses inspectional analysis to derive the minimum set of 6 dimensionless numbers that can be used to characterise a polymer flood in a two layered model. A series of finely gridded numerical simulations are then performed to determine the contribution of viscous crossflow to oil recovery from secondary and tertiary polymer flooding in this system. We show that viscous cross-flow will only make a positive impact on oil recovery from secondary polymer flooding when the viscosity ratio values of oil to polymer solution is less than 1 and permeability ratio between the layers is less than 50. Furthermore, we show that there is an inverse relationship between the permeability ratio between layers and the amount of degradation the polymer slug experiences due to viscous crossflow in the high permeability layer. As the permeability contrast between layers increases, the slug degradation decreases. Also, the results show that the desired positive impact from viscous crossflow is higher in secondary polymer foods when compared to tertiary polymer floods. Finally, the results can be used to make initial estimates of the contribution of both viscous cross-flow and mobility control in polymer flooding applications without the need to perform extensive and time consuming numerical simulations.

Loading

Article metrics loading...

/content/papers/10.3997/2214-4609.201700331
2017-04-24
2024-04-20
Loading full text...

Full text loading...

References

  1. Ahmed, G., Castanier, L. M. and Brigham, W. E.
    [1988] An experimental Study of Waterflooding From a Two-Dimensional Layered Sand Model. SPE Reservoir Engineering, Society of Petroleum Engineers, 3. 45–54.
    [Google Scholar]
  2. AlHamdan, M., Cinar, Y., Suicmez, V. S., and Dindoruk, B.
    [2011]. Experimental and Numerical Study of Compositional Two-Phase Displacements in Layered Porous Media. SPE Reservoir Characterisation and Simulation Conference and Exhibition, 9–11 October, Abu Dhabi, UAE. doi:10.2118/147967‑MS
    https://doi.org/10.2118/147967-MS [Google Scholar]
  3. Cinar, Y., Jessen, K., Berenblyum, R., Juanes, R., and Orr, F. M.
    [2006]. An Experimental and Numerical Investigation of Crossflow Effects in Two-Phase Displacements. SPE Journal, Society of Petroleum Engineers. 11, 216–226. doi:10.2118/90568‑PA
    https://doi.org/10.2118/90568-PA [Google Scholar]
  4. Clifford, P. J. and Sorbie, K. S.
    [1985] The Effects of Chemical Degradation on Polymer Flooding. SPE Oilfield and Geothermal Chemistry Symposium. Phoenix, USA: Society of Petroleum Engineers.
    [Google Scholar]
  5. Debbabi, Y., Jackson, M. D., Hampson, G. J., Fitch, P. J. R., and Salinas, P.
    [2016] The interplay of Capillary and Viscous Forces Driving Flow through Layered Porous Media. 15th Eropean Conference on the Mathematics of Oil Recovery 29thAugust – 1st September, Amsterdam, Netherlands.
    [Google Scholar]
  6. Lake, L. W.
    [1989] Enhanced Oil Recovery, Prentice Hall.
    [Google Scholar]
  7. Pye, D. J.
    [1964] Improved secondary recovery by control of water mobility. Journal of Petroleum Technology, 16, 911–916.
    [Google Scholar]
  8. Sandiford, B. B.
    [1964] Laboratory and Field Studies of Water Floods Using Polymer Solutions to Increase Oil Recoveries. Journal of Petroleum Technology, 16, 16.
    [Google Scholar]
  9. Seright, R. S.
    [2016]. How Much Polymer Should Be Injected During a Polymer Flood? Review of Previous and Current Practices. Society of Petroleum Engineers. doi:10.2118/179543‑PA
    https://doi.org/10.2118/179543-PA [Google Scholar]
  10. Shook, M., Li, D., Lake, L. W.
    [1992] Scaling Immisible Flow Through Permeable Media by Inspectional Analysis. In-Situe, 4, 311–349.
    [Google Scholar]
  11. Shotton, M., Stephen, K. and Giddins, M.
    [2016] High-Resolution Sudies of Polymer Flooding in Heterogeneous layered Reservoirs. SPE EOR Conference at Oil and Gas West Asia. Muscat, Oman, 21–23 March, 2016.
    [Google Scholar]
  12. Sorbie, K. S. and Seright, R. S.
    [1992] Gel Placement in Heterogeneous Systems with Crossflow. 8th SPE/DOE Symposium on Enhanced Oil Recovery. Tulsa, Oklahom, April 22–24, 1992.
    [Google Scholar]
  13. Sorbie, K. S.
    [1991] Polymer-Improved Oil Recovery, Blackie.
    [Google Scholar]
  14. Sorbie, K. S., Sheb, M., Hosseini, A. and Wat, R. M. S.
    [1990] Scaled Miscible Floods in Layered Beadpacks Investigating Viscous Crossflow, the Effects of Gravity, and the Dynamics of Viscous Slug Breakdown. SPE Annual Technical Conference and Exhibition. New Orleans: Society of Petroleum Engineers.
    [Google Scholar]
  15. Sorbie, K. S. and Walker, D. J.
    [1988] A Study of the Mechanism of Oil Displacement Using Water and Polymer in Stratified Laboratory Core Systems. SPE Enhanced Oil Recovery Symposium. Tulsa, USA: Society of Petroleum Engineers.
    [Google Scholar]
  16. Wright, R. J., Wheat, M. R., and Dawe, R. A.
    [1987]. Slug Size and Mobility Requirements for Chemically Enhanced Oil Recovery Within Heterogeneous Reservoirs. SPE Reservoir Engineering, Society of Petroleum Engineers, 2, 92–102 doi:10.2118/13704‑PA
    https://doi.org/10.2118/13704-PA [Google Scholar]
  17. Zapata, V. J. and Lake, L. W.
    [1981]. A Theoretical Analysis of Viscous Crossflow. SPE Annual Technical Conference and Exhibition, San Antonio, Texas, October 4–7 doi:10.2118/10111‑MS
    https://doi.org/10.2118/10111-MS [Google Scholar]
http://instance.metastore.ingenta.com/content/papers/10.3997/2214-4609.201700331
Loading
/content/papers/10.3997/2214-4609.201700331
Loading

Data & Media loading...

This is a required field
Please enter a valid email address
Approval was a Success
Invalid data
An Error Occurred
Approval was partially successful, following selected items could not be processed due to error