1887

Abstract

Summary

In naturally fractured carbonate reservoirs, Gas Oil Gravity Drainage processes (GOGD) are successfully implemented but oil recovery is limited by a slow kinetics. However a gas EOR process represents a promising alternative to boost this oil production rate. Nevertheless the design of this process should address several technical challenges: the typically unfavorable wettability of the matrix (intermediate to strongly oil-wet), the densely connected fracture network and the high contrast of fracture-to-matrix permeability.

We propose here the injection of an advanced EOR foam with reduced interfacial tensions. The foam flow in the fracture creates an important viscous drive by imposing a pressure gradient, thus enhancing the oil recovery dynamics compared to GOGD. Besides, the reduced interfacial tension (IFT) between crude oil and aqueous phase allows the aqueous phase to enter the matrix despite the unfavorable wettability.

In this paper, we demonstrate that a balance exist between IFT and foam strength performances to optimize the process. Three foam formulations are optimized with very different profiles in terms of IFT and foam performances. For their design, priority is given either to ultra-low IFT values (0.001mN/m) or to a strong foam with larger IFT (0.15mN/m) or to a balance between the two first formulations (0.03mN/m). These formulations are compared in vials, sandpack and coreflood experiments (fractured cores). Foams are evidenced as intrinsically less stable in ultra-low IFT conditions: foam stability (in vials) and apparent viscosity (in porous media) in contact with oil are respectively enhanced by a factor 30 and by two decades when IFT rises from 0.001 to 0.1mN/m. Based on sandpack and coreflood experiments, we recommend an IFT of 0.1 to 0.01mN/m as a balance between the viscous drive in fracture and an efficient aqueous phase imbibition in the oil-wet matrix. Simulation work supports this experimental conclusion: the common target of IFT of the order of 0.001 mN/m determined by capillary desaturation curves in SP flooding can be revised to a higher IFT, which is can be deduced from the wettability of the reservoir.

To ensure an accelerated oil recovery in naturally fractured carbonate reservoirs, we recommend the design of a low-IFT foam formulation with revised IFT performances compared to a classical Surfactant-Polymer process. This article gives the target formulation parameters which arise from the mechanisms at play (viscous drive and imbibition in oil-wet matrix), and are realistically achieved with industrial surfactants.

Loading

Article metrics loading...

/content/papers/10.3997/2214-4609.201900144
2019-04-08
2024-04-20
Loading full text...

Full text loading...

References

  1. Batôt, G., M. Fleury, E. Rosenberg, L. Nabzar, and M. Chabert.
    2016. « Foam Propagation in Rock Samples: Impact of Oil and Flow Caracterization ». In . Society of Petroleum Engineers. https://doi.org/10.2118/179855-MS.
    [Google Scholar]
  2. Bouquet, S, FDouarche, FRoggero, and BBourbiaux
    . 2019. « Numerical Assessment and Optimization of Foam-Based EOR Processes in Naturally Fractured Carbonate Oil-Wet Reservoirs ». In . Pau.
    [Google Scholar]
  3. Cantat, Isabelle, SylvieCohen-Addad, FlorenceElias, FrançoisGraner, ReinhardHöhler, OlivierPitois, FlorenceRouyer, ArnaudSaint-Jalmes, and RuthFlatman
    . 2013. Foams: Structure and Dynamics. Édité par Simon Cox. Oxford University Press. https://doi.org/10.1093/acprof:oso/9780199662890.001.0001.
    [Google Scholar]
  4. Chabert, M., L.Nabzar, M.Morvan, S.Rohaida Mohd Shafian, P.Abdul Hamid, M.Faizal Sedaralit, and N.Darman
    . 2013. « An Integrated Laboratory Workflow for the Design of a Foam Pilot in Malaysia ». In . https://doi.org/10.3997/2214-4609.20142648.
    [Google Scholar]
  5. Chevallier, Eloise, MaxChabert, SergeGautier, HamidGhafram, SajaKhaburi, and AbdullahAlkindi
    . 2018. « Design of a Combined Foam EOR Process for a Naturally Fractured Reservoir ». In . Society of Petroleum Engineers. https://doi.org/10.2118/190363-MS.
    [Google Scholar]
  6. Chevallier, Eloise, Oceane Tchamba, Max Chabert, Samir Bekri, Frederic Martin, and Serge Gautier
    . 2015. « Foams with Ultra-Low Interfacial Tensions for an Efficient EOR Process in Fractured Reservoirs ». In . Society of Petroleum Engineers. https://doi.org/10.2118/174658-MS.
    [Google Scholar]
  7. Denkov, Nikolai D.
    2004. « Mechanisms of Foam Destruction by Oil-Based Antifoams ». Langmuir20 (22): 9463–9505. https://doi.org/10.1021/la049676o.
    [Google Scholar]
  8. Dong, Pengfei, Maura Puerto, Kun Ma, Khalid Mateen, Guangwei Ren, Gilles Bourdarot, Danielle Morel, Sibani Lisa Biswal, and George Hirasaki
    . 2018. « Ultralow-Interfacial-Tension Foam Injection Strategy Investigation in High Temperature Ultra-High Salinity Fractured Carbonate Reservoirs ». In . Society of Petroleum Engineers. https://doi.org/10.2118/190259-MS.
    [Google Scholar]
  9. Dong, Pengfei, Maura Puerto, Kun Ma, Khalid Mateen, Guangwei Ren, Gilles Bourdarot, Danielle Morel, Maurice Bourrel, Sibani Lisa Biswal, and George Hirasaki
    . 2017. « Low-Interfacial-Tension Foaming System for Enhanced Oil Recovery in Highly Heterogeneous/Fractured Carbonate Reservoirs ». In . Society of Petroleum Engineers. https://doi.org/10.2118/184569-MS.
    [Google Scholar]
  10. EloïseChevallier, NilsDemazy, AmandineCuenca, et MaxChabert
    . 2018. « Evolution of foam performances in porous media and its flow structure with foam formulation properties ». In press, 12 décembre 2018, Transport In Porous Media édition.
    [Google Scholar]
  11. Lachaise, J., T.Breul, A. Graciaa, G.Marion, A.Monsalve, and J.L.Salager
    . 1990. « Foaming Properties of Surfactant-Oil-Water Systems in the Neighbourhood of Optimum Formulation ». Journal of Dispersion Science and Technology11 (5): 443–53. https://doi.org/10.1080/01932699008943270.
    [Google Scholar]
  12. Li, Robert Feng, GeorgeJ. Hirasaki, ClarenceA. Miller, and ShehadehK. Masalmeh
    . 2011. « Wettability Alteration and Foam Mobility Control in a Layered 2-D Heterogeneous System ». In . Society of Petroleum Engineers. https://doi.org/10.2118/141462-MS.
    [Google Scholar]
  13. Sheng, James.
    2013. « A Comprehensive Review of Alkaline-Surfactant-Polymer (ASP) Flooding ». In . Society of Petroleum Engineers. https://doi.org/10.2118/165358-MS.
    [Google Scholar]
  14. Srivastava, Mayank, JieyuanZhang, Quoc PhucNguyen, and Gary A.Pope.
    2009. « A Systematic Study of Alkali Surfactant Gas Injection as an Enhanced Oil Recovery Technique ». In . Society of Petroleum Engineers. https://doi.org/10.2118/124752-MS.
    [Google Scholar]
  15. Tabary, Rene, FredericDouarche, BrigitteBazin, PierreLemouzy, PatrickMoreau, and MikelMorvan
    . 2012. « Design of a Surfactant/Polymer Process in a Hard Brine Context: A Case Study Applied to Bramberge Reservoir ». In . Society of Petroleum Engineers. https://doi.org/10.2118/155106-MS.
    [Google Scholar]
  16. Verlaan, Marco, and Paulus MariaBoerrigter
    . 2006. « Miscible Gas-Oil Gravity Drainage ». In . Society of Petroleum Engineers. https://doi.org/10.2118/103990-MS.
    [Google Scholar]
  17. Wang, Demin, JiechengCheng, ZhenyuYang, LiQun, WenxiangWu, and HuiyuYu.
    2001a. « Successful Field Test of the First Ultra-Low Interfacial Tension Foam Flood ». In . Society of Petroleum Engineers. https://doi.org/10.2118/72147-MS.
    [Google Scholar]
  18. WangDemin, ChengJiecheng, YangZhenyu, QunLi, WuWenxiang, YuHuiyu.
    2001b. « Successful Field Test of the First Ultra-Low Interfacial Tension Foam Flood ». In . Society of Petroleum Engineers. https://doi.org/10.2118/72147-MS.
    [Google Scholar]
  19. Zhang, Chengli, PengWang, GuoliangSong, GuodongQu, and JialunLiu.
    2018. « Optimization and Evaluation of Binary Composite Foam System with Low Interfacial Tension in Low Permeability Fractured Reservoir with High Salinity ». Journal of Petroleum Science and Engineering 160 (janvier): 247–257. https://doi.org/10.1016/j.petrol.2017.10.047.
    [Google Scholar]
  20. Zhang, Yunxiang, XianganYue, JianxiaDong, and LiuYu.
    2000. « New and Effective Foam Flooding To Recover Oil in Heterogeneous Reservoir ». In . Society of Petroleum Engineers. https://doi.org/10.2118/59367-MS.
    [Google Scholar]
http://instance.metastore.ingenta.com/content/papers/10.3997/2214-4609.201900144
Loading
/content/papers/10.3997/2214-4609.201900144
Loading

Data & Media loading...

This is a required field
Please enter a valid email address
Approval was a Success
Invalid data
An Error Occurred
Approval was partially successful, following selected items could not be processed due to error